Surface characteristics of different wood and coal-based activated carbons for preparation of carbon molecular sieve



Document title: Surface characteristics of different wood and coal-based activated carbons for preparation of carbon molecular sieve
Journal: Journal of the Mexican Chemical Society
Database: PERIÓDICA
System number: 000437835
ISSN: 1870-249X
Authors: 1
2
1
3
4
Institutions: 1Islamic Azad University, Department of Chemistry, Teherán. Irán
2Islamic Azad University, Department of Environmental Engineering, Teherán. Irán
3Islamic Azad University, Faculty of Chemistry, Teherán. Irán
4Research Institute of Petroleum Industry, Teherán. Irán
Year:
Season: Abr-Jun
Volumen: 63
Number: 2
Country: México
Language: Inglés
Document type: Artículo
Approach: Experimental, analítico
Spanish abstract En este estudio, se seleccionaron cuatro precursores de nanoestructuras diferentes, madera de pistache, madera de nueces, madera de bosque y carbón (antracita) para producir carbón activado. Los experimentos se realizaron a escala industrial utilizando un horno rotatorio con una temperatura entre 850 y 920 ºC durante 45 minutos, seguido de vapor. El producto se molió y se dividió en tres tamaños de partículas, en mallas de 8x30, 30x50 y 60x80. Las propiedades físicas y la química de la superficie de las muestras de carbón activado se determinaron mediante imágenes de la adsorción de BET-N2. Los resultados obtenidos de las mediciones de los números de yodo y azul de metileno, área de superficie, volumen de poros y comparación de área de superficie y volumen de poros muestran que, al disminuir los tamaños de partícula de cada muestra, aumenta significativamente el área de superficie y los volúmenes de microporos. La magnitud de los cambios en el área de la superficie con el tamaño de partícula es un factor significativo en la definición de la efectividad y la idoneidad de un carbón activado para la producción de tamiz molecular de carbono. Nuestros resultados indican que el mayor volumen de poros pertenece a la madera de pistache, que aumentó de la malla de 0.168 a 0.271 cm3/g de 8x30 a 60x80
English abstract In this study, four different nanostructures precursors, pistachio wood, walnuts wood, forest wood and coal (Anthracite) were selected to produce activated carbon. The experiments were done in industrial scale using a rotary furnace with temperature between 850 and 920 ºC for 45 minutes followed by steam. The product was grounded and divided in three particle sizes, 8x30, 30x50, and 60x80 meshes. The physical properties and surface chemistry of the activated carbon samples were determined by imaging of BET-N2 adsorption. The results obtained from measurements of iodine and methylene blue numbers, surface area, pore volume and comparison of surface area and pore volume, show that by decreasing of particle sizes of each sample, increase the surface area and micro pore volumes significantly. The magnitude of changes in surface area with particle size is a significant factor in defining the effectiveness and suitability of an activated carbon for the production of carbon molecular sieve. Our results indicate that the highest pore volume belongs to pistachio wood, which was increased from 0.168 to 0.271 cm3/g from 8x30 to 60x80 mesh
Disciplines: Ingeniería
Keyword: Ingeniería de materiales,
Carbón activado,
Superficie de área,
Volumen de poro,
Nanoestructuras,
Tamiz
Keyword: Materials engineering,
Activated carbon,
Surface area,
Pore volume,
Nanostructures,
Sieve
Full text: Texto completo (Ver HTML) Texto completo (Ver PDF)