Effects of drying temperature and relative humidity on the mechanical properties of amaranth flour films plasticized with glycerol
Tapia-Blacido, D¹; Sobral, P.J²; Menegalli, F.C
¹Universidade Estadual de Campinas, Faculdade de Engenharia de Alimentos, Campinas, Sao Paulo. Brasil; ²Universidade de Sao Paulo, Faculdade de Zootecnia e Engenharia de Alimentos, Pirassununga, Sao Paulo. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 249-256]

Experimental determination of the effect of temperature and humidity on the development of colour in Pinus radiata
McCurdy, M¹; Pang, S; Keey, R
¹University of Canterbury, Wood Technology Research Center, Christchurch, Canterbury. Nueva Zelanda
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 173-179]

Fluidized bed spray granulation: analysis of heat and mass transfers and dynamic particle populations
Heinrich, S¹; Henneberg, M; Peglow, M; Drechsler, J; Morl, L
¹Otto von Guericke University, Institute of Process Equipment and Environmental Technology, Magdeburgo, Sajonia-Anhalt. Alemania
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 181-194]

Investigation of coalescence kinetics of microcristalline cellulose in fluidised bed spray agglomeration: experimental studies and modelling approach
Peglow, M¹; Kumar, J; Morl, L
¹Otto von Guericke University of Magdeburg, Institute of Process Equipment and Environmental Technology, Magdeburgo, Sajonia-Anhalt. Alemania
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 165-172]

Investigation of paper dryer picking, web transfer and quality issues using a new web adhesion and drying simulator
Ahrens, F¹; Patterson, T; Mueller, S; Hojjatie, B
¹Georgia Institute of Technology, Institute of Paper Science and Technology, Atlanta, Georgia. Estados Unidos de América
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 217-225]

Modeling and simulation of milk emulsion drying in spray dryers
Birchal, V.S¹; Passos, M.L^2
1Universidade Federal de Minas Gerais, Programa de Pos-Graduacao em Engenharia Mecanica, Belo Horizonte, Minas Gerais. Brasil; ²Universidade Federal de Sao Carlos, Centro de Secagem, Sao Carlos, Sao Paulo. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 293-302]

Modelling and simulation of drying phenomena with rheological behaviour
Chemkhi, S¹; Zagrouba, F; Bellagi, A^2
1Institut National de Recherche Scientifique et Technique, Laboratoire Energetique et Procedes Thermiques, Hammam-Lif. Túnez; ²Ecole Nationale d'Ingenieurs de Monastir, Monastir. Túnez
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 153-163]

Modelling the drying of a parallelepipedic oil shale particle
Porto, P.S.S¹; Lisboa, A.C.L
¹Universidade Estadual de Campinas, Faculdade de Engenharia Quimica, Campinas, Sao Paulo. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 233-238]

Overview of new techniques for drying biological materials with emphasis on energy aspects
Raghavan, G.S.V¹; Rennie, T.J; Sunjka, P.S; Orsat, V; Phaphuangwittayakul, W²; Terdtoon, P
¹McGill University, Department of Bioresource Engineering, Ste. Anne de Bellevue, Quebec. Canadá; ²Chiang Mai University, Department of Mechanical Engineering, Chiang Mai. Tailandia
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 195-201]

Spouted bed drying of Bauhinia forficata link extract: the effects of feed atomizer position and operating conditions on equipment performance and product properties
Souza, C.R.F¹; Oliveira, W.P
¹Universidade de Sao Paulo, Faculdade de Ciencias Farmaceuticas de Ribeirao Preto, Ribeirao Preto, Sao Paulo. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 239-247]

The drying of amaranth grain: mathematical modeling and simulation
Calzetta Resio, A¹; Aguerre, R.J²; Suarez, C^3
1Universidad de Buenos Aires, Facultad de Ciencias Veterinarias, Buenos Aires. Argentina; ²Universidad Nacional de Luján, Departamento de Tecnología, Luján, Buenos Aires. Argentina; ³Universidad de Buenos Aires, Facultad de Ciencias Exactas y Naturales, Buenos Aires. Argentina
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 303-309]

The drying of sewage sludge by immersion frying
Silva, D.P¹; Rudolph, V²; Taranto, O.P
¹Universidade Estadual de Campinas, Faculdade de Engenharia Quimica, Campinas, Sao Paulo. Brasil; ²University of Queensland, School of Engineering, St. Lucia, Queensland. Reino Unido
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 271-276]

The effects of fixed-bed drying on the yield and composition of essential oil from long pepper (Piper hispidinervium C. DC) leaves
Braga, N.P¹; Cremasco, M.A; Valle, R.C.C.R^2
1Universidade Estadual de Campinas, Faculdade de Engenharia Quimica, Campinas, Sao Paulo. Brasil; ²Universidade Regional de Blumenau, Departamento de Engenharia Quimica, Blumenau, Santa Catarina. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 2 Jun, Pág. 257-262]

Adsorption of ethyl acetate onto modified clays and its regeneration with supercritical CO2
Cavalcante, A.M¹; Torres, L.G; Coelho, G.L.V
¹Universidade Federal Rural do Rio de Janeiro, Departamento de Engenharia Quimica, Rio de Janeiro. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 75-82]

Analysis of techniques for measurement of the size distribution of solid particles
Arouca, F.O¹; Barrozo, M.A.S; Damasceno, J.J.R
¹Universidade Federal de Uberlandia, Faculdade de Engenharia Quimica, Uberlandia, Minas Gerais. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 135-142]

Determination of inhibition in the enzymatic hydrolysis of cellobiose using hybrid neural modeling
Corazza, F.C¹; Calsavara, L.P.V; Moraes, F.F; Zanin, G.M; Neitzel, I
¹Universidade Estadual de Maringa, Departamento de Engenharia Quimica, Maringa, Parana. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 19-29]

Front tracking in recirculating flows: a comparison between the TVD and RCM methods in solving the VOF equation
Silva, L.F. Lopes¹; Fontes, C.E; Lage, P.L.C
¹Universidade Federal do Rio de Janeiro, Instituto Alberto Luiz Coimbra de Pos-Graduacao e Pesquisa de Engenharia, Rio de Janeiro. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 105-116]

Improvement of lipase production at different stirring speeds and oxygen levels
Alonso, F.O.M¹; Oliveira, E.B.L; Dellamora Ortiz, G.M; Pereira-Meirelles, F.V^2
1Universidade Federal do Rio de Janeiro, Faculdade de Farmacia, Rio de Janeiro. Brasil; ²Pontificia Universidade Catolica do Rio de Janeiro, Departamento de Quimica, Rio de Janeiro. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 9-18]

Monitoring emulsion homopolymerization reactions using FT-Raman spectroscopy
Reis, M.M¹; Uliana, M; Sayer, C; Araujo, P.H.H; Giudici, R
¹Universidade de Sao Paulo, Escola Politecnica, Sao Paulo. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 61-74]

Optimization of the process of concentration of vitamin e from DDSO using supercritical CO2
Mendes, M.F¹; Pessoa, F.L.P²; Uller, A.M.C
¹Universidade Federal do Rio de Janeiro, Instituto Alberto Luiz Coimbra de Pos-Graduacao e Pesquisa de Engenharia, Rio de Janeiro. Brasil; ²Universidade Federal do Rio de Janeiro, Escola de Quimica, Rio de Janeiro. Brasil
[Brazilian journal of chemical engineering, Brasil, 2005 Vol. 22 Núm. 1 Mar, Pág. 83-91]