Efecto de la carga hidráulica sobre las remociones de Cd (II) y Cr (VI) en un reactor tipo biodiscos de tres etapas



Título del documento: Efecto de la carga hidráulica sobre las remociones de Cd (II) y Cr (VI) en un reactor tipo biodiscos de tres etapas
Revista: Impacto científico
Base de datos: CLASE
Número de sistema: 000477124
ISSN: 1856-5042
Autores: 1
1
1
1
1
Instituciones: 1Universidad del Zulia, Facultad de Ingeniería, Maracaibo, Zulia. Venezuela
Año:
Periodo: Dic
Volumen: 12
Número: 2
Paginación: 143-160
País: Venezuela
Idioma: Español
Tipo de documento: Artículo
Enfoque: Analítico, descriptivo
Resumen en español La contaminación ambiental por metales pesados resulta principalmente de la inadecuada disposición de desechos antropogénicos, entre los que se encuentran: efluentes industriales, drenajes de minas, lixiviados de materiales tóxicos, entre otros. El objetivo de esta investigación fue evaluar el efecto de la carga hidráulica sobre las remociones de Cd(II) (5 mg/L) y Cr(VI) (20 mg/L) en un reactor tipo biodiscos de tres etapas, durante el tratamiento de un efluente industrial sintético, a escala laboratorio y bajo condiciones mesofílicas. Los ensayos se desarrollaron a flujo continuo, considerando tiempos de retención hidráulica (TRH) de 18, 8 y 4 h, estableciendo la adecuación del efluente tratado respecto a la normativa ambiental venezolana de descarga. El reactor tuvo un volumen útil de 8 L y un área total de contacto de los discos de 1,836 m2 . Los parámetros monitoreados fueron: pH, alcalinidad total, oxígeno disuelto, potencial redox, turbidez, demanda química de oxígeno soluble(DQOS ) y total (DQOT), sólidos suspendidos totales (SST) y volátiles (SSV),así como las concentraciones de Cd y Cr, aplicando métodos estandarizados. Se observó un efecto altamente significativo (p<0,001) de la carga hidráulica sobre las variables fisicoquímicas analizadas, excepto para SST y SSV. El TRH óptimo para el tratamiento del efluente sintético fue de 8 h (carga hidráulica de 13,07 L/d.m2 ), con remociones de materia orgánica de 71,32 % como DQOT y 72,34 % como DQOS , Cd (II) de 97,62 % y Cr (VI) de 58,90 %. No obstante, se requiere de un tratamiento adicional para adecuar el contenido final de Cr al límite de descarga establecido por la normativa legal vigente
Resumen en inglés The environmental pollution by heavy metals results mainly from the inadequate disposal of anthropogenic wastes, including industrial effluents, mine drainage; leach ate from toxic materials, among others. The objective of this research was to evaluate the effect of hydraulic load on Cd (II) (5 mg/L) and Cr (VI) (20 mg/L) removals in a 3-stage RBC reactor during treatment of a synthetic industrial effluent, at laboratory scale and under mesophilic conditions. The tests were developed at a continuous flow, considering hydraulic retention times (HRT) of 18, 8 and 4 h, establishing suitability of the treated effluent with respect to Venezuelan environmental discharge regulations. The reactor had a useful volume of 8 L and a total contact area of the disks of 1.836 m2 . The parameters monitored were pH, total alkalinity, dissolved oxygen, red ox potential, turbidity, soluble chemical oxygen demand (CODS ) and total (CODT), total suspended solids (TSS) and volatile (VSS), Cd and Cr concentrations, applying standardized methods. A highly significant effect (p<0.001) of the hydraulic load on the physicochemical variables analyzed was observed, except for TSS and VSS. The optimum HRT for treatment of the synthetic effluent was 8 h (hydraulic load of 13.07 L/d.m2 ), with organic matter removal of 71.32% as CODT and 72.34% as CODS , Cd (II) of 97.62% and Cr (VI) of 58.90%. However, an additional treatment to adapt the final Cr content to the discharge limit established by current legal regulations is required
Disciplinas: Ingeniería
Palabras clave: Ingeniería ambiental,
Remoción,
Metales pesados,
Carga hidráulica,
Reactor de biodiscos,
Residuos industriales,
Tratamiento de aguas
Texto completo: Texto completo (Ver PDF)